Questions?

FAQ

How it Works

Send Message to us.

805-288-7338

contact@tutorz.com

electrical circuits, Columbia, MD 21044

Hi there, I am doing a class project, and facing some issues and your help if you can help me to figure them out, I appreciate that in advance. I want to do a circuit diagram to power on two sensors that are using 5 VDC. The circuit will be used to make a direct measurement of Blood pressure and airflow and will serve as the gateway to the recording system (which I have no idea how it operates and I should consider it as simple oscilloscope). My goal is to use a voltage regulator and a unity gain amplifier as a buffer,However. I am confused on where to put the voltage regulator? The block diagram i am proposing is 1: 12 VDC battery-> 2: voltage regulator ( to maintain 5 VDC with three capacitors) ->3: opamp with unity gain ->4: connect to the oscilloscope. Is this correct? Also, my other question: since I am using two sensors, should I use two voltage regulators or only one? for sure I need to opamps to have two channels output. I appreciate your help in advance and looking forward to hear from you soon. Best Regards. A.

Sent by Awadh on Jan 18

Setup FREE profile

to buy Awadh's job about electrical circuits in Columbia, MD 21044

Create Your Tutoring Profile

Please enter your first and last name.
Please enter your valid email address.  is already in use. Choose a different email to register or login to your existing account.
Password must be at least 6 symbols.
Passwords don't match, please retype.
captchas prevent mass-access by robots The text didn't match. Try again!
Please correct the error(s) above.
Matt Horwich's testimonial

Matt Horwich

  • I like TutorZ because as soon as I get a notification, I purchase the lead for as little as two dollars. Within minutes I have made a call or sent a direct email. I usually set up a first session for that week....sometimes that very same day! Now let's start studying....

by Matt Horwich, Cleveland, OH

More Testimonials